No.0 PP Hollow Sheet Crease & Bending Machine

A hollow sheet collapses if you simply fold it. This machine creases the line first, then folds along it — effectively forming a hinge, so the corner stays clean and spring-back stays small.
What it solves
01Folding a sandwich panel crushes the core and bulges the line.
Without core support the outer facing buckles and whitens.
Creasing and bending on separate machines means moving the sheet twice.
Core value
02Crease then bend, on one machine.
Depth adjustable from 0.5 mm.
25 seconds per sheet.
How it works
03- 01Crease first
The creasing blade collapses the core along the line while the facings stay continuous.
- 02Then bend
The bending station folds along the same line, so the angle is stable.
- 03Depth adjustable
Crease depth from 0.5 mm to full thickness: thin sheet is not cut through, thick sheet is fully creased.
- 04Two processes, one machine
Creasing and bending run in sequence on one table.
Specifications
04| Sheet thickness | 1–30 mm (0.04 in–1.2 in) |
|---|---|
| Crease / bend length | 1600 mm (5.2 ft) |
| Crease depth | 0.5 mm (0.02 in) to sheet thickness |
| Cycle | crease 10 s + bend 15 s |
| Power | 6 kW |
| Voltage / air | 380 V / 0.5 MPa |
Advantages
05Creasing
- Depth adjustable for 1–30 mm sheet.
- Blade width interchangeable, crease width set by the workpiece.
- 10 seconds to crease, 15 seconds to bend.
Forming
- Clean corner without bulging; the core stays supported.
- Low spring-back, so no re-setting after the bend.
- Aluminium table heats only the fold line.
What it bends
06Machine detail


Video
Post a 200 × 200 mm offcut with material and thickness noted; we bend it to your angle and send photos plus video within 48 hours.
Request a trial bendAlso known as
07All names above refer to this machine — see the full alias index.
FAQ
08Can hollow sheet be folded directly?
No. The core collapses; it must be creased first and folded along that line.
Can the crease cut through the facing?
No. Depth is adjustable from 0.5 mm to full thickness.

