No.0 Three-Edge Automatic Plastic Bending Machine

Fold a U-shape one side at a time and every clamping adds error, so the two edges never line up. Three heating lines soften three fold lines at once, and one press forms all three edges.
What it solves
01Fold, measure, fold again: the error accumulates.
Every move is another chance of a mark or a scratch.
U-width guessed with shims; batch parts vary.
Core value
02Three folds, one press.
U-width 350–700 mm.
Lines switch independently.
How it works
03- 01Three lines at once
Three heating lines soften three fold lines simultaneously.
- 02Independent switching
Use one or two lines when the job needs fewer folds.
- 03Handwheel pitch
Line pitch adjusted by handwheel, U-width 350–700 mm.
- 04One press
All three folds come from the same datum, so the dimension chain does not accumulate.
Specifications
04| Sheet thickness | 0.8–6 mm (0.03 in–0.24 in) (acrylic) |
|---|---|
| Working length | 1600 mm (5.2 ft) |
| Heating lines | 3, independently switchable |
| U-shape pitch | 350–700 mm (1.1 ft–2.3 ft) |
| Cooling | air |
| Voltage / power / air | 220 V / 5 kW / 0.5 MPa |
Advantages
05Forming
- Three folds in one press: no accumulated error.
- One clamping for thin sheet, fewer marks.
- U-width 350–700 mm, consistent across the batch.
Operation
- Pneumatic drive with automatic positioning.
- Manual and automatic modes.
- Heating lines switched independently for single folds.
What it bends
06Machine detail


Video
Post a 200 × 200 mm offcut with material and thickness noted; we bend it to your angle and send photos plus video within 48 hours.
Request a trial bendAlso known as
07All names above refer to this machine — see the full alias index.
FAQ
08Can I use only one heating line?
Yes. The three lines switch independently, so single and double folds are possible.
What U-width is possible?
350–700 mm, set by handwheel on the line pitch.




